Westinghouse GHP17S Manual de usuario Pagina 6

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 16
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 5

  
Burner will not light
even though the sparker
is working
Knob not held down long enough
in ‘High’ position for flame safeguard
(where fitted) to engage
Repeat lighting procedure and hold knob
down for 5 seconds in ‘High’ position (refer
page 4)
Gas supply valve turned off Turn on gas supply to appliance
Wrong knob turned • Ensure the knob you are turning corresponds
to the burner you want to light
Port blockage in ignition area Ensure that ports in ignition area are clean
and dry
• Ignition spark plugs wet or dirty • Dry or clean ignition spark plugs
No spark is obtained
when control knob
is activated
Electricity supply is disconnected or
switched off
• Switch on electricity or check fuses
• Ignition spark plugs wet or dirty Dry or clean ignition spark plugs
Flames uneven or
tending to lift
• Flame ports blocked or wet • Clean or dry ame ports
• Burner incorrectly tted • Ensure this component is tted correctly
Flames not staying on
when knob released
• Knob not held down long enough in
‘High’ position for flame safeguard
(where fitted) to engage
• Repeat lighting procedure and hold knob
down for 5 seconds in ‘High’ position (refer
page 4)
• Knob not set between ‘High’ and
‘Low’
• Knob MUST be set between these positions.
• Dirt or spillage on ame safeguard
sensor (where fitted)
• Clean ame safe guard sensor tip
Low heat, slow cooking
• Incorrect cooking pot or pan being used • Refer to Figure 3 (page 5)
Benchtop or knobs
overheating
• Incorrect cooking pot or pan used Check Figure 3 for correct pot or pan to be used
Pot or pan not located on burner
properly
Ensure pot or pan is centrally located
on burner
If you have a problem with the cooktop, check the table below. You may be able to solve the problem and this will
save you from paying for a service call. You will have to pay for a service call even in the warranty period if the
problem is one listed below.
If the above points have been checked and there is still a problem with the cooktop, please call the Service Centre.
Vista de pagina 5
1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Comentarios a estos manuales

Sin comentarios